RIGEXPERT STANDARD Ampliar

RIGEXPERT STANDARD

BUEN ESTADO

Más detalles

0000001915

1 artículo disponible

Advertencia: ¡Últimos artículos en inventario!

100,00 €

EMBALAJE ORIGINAL

 CD

CABLE USB

MIRAR FOTOS

Transceiver audio interface:
Analog audio interface is a connection to transceiver audio output (external speaker connector or line output) and transceiver audio input (microphone connector or line input). Audio interface enables operating digital modes, recording and playing voice, as well as other useful functions (such as measuring levels of a signal from the air) by using a computer. Input (two channels) and output volume levels are adjusted by potentiometers on the front panel of the device.

- Optical S/PDIF in/out:
In addition to the analog audio interface, RigExpert Plus provides optical S/PDIF input and output for modern transceivers such as IC-7800. The optical cables are widely available in HI-FI stores.

- CAT interface for various transceiver models:
CAT (Computer Aided Transceiver) system provides control of transceiver frequency, operating mode and other functions by computer software. Normally, modern transceivers have serial (with various signal levels) link providing CAT interface. In RigExpert Plus, CAT interface port is seen as a COM port by computer software.

- FSK output:
FSK (Frequency Shift Keying) is a popular method of transmitting digital messages over radio primarily used in radioteletype (RTTY) mode. Most transceivers provide FSK modulator feature to make the RTTY signal stable and clear. A separate COM port is assigned for the FSK output when using RigExpert Plus. The FSK baudrate and polarity are fixed and may be reconfigured by jumpers.

- PTT and CW output functions:
Transceivers provide PTT (Push To Talk) and CW (Continuous Wave) keyer inputs to allow setting the transmitter on or off and operating CW using external device (PTT pedal, CW bug or paddle, terminal node controller, or personal computer). In RigExpert Plus, PTT and CW outputs are assigned to the RTS and DTR lines of a separate COM port.

- Squelch input:
Some software, such as EchoLink, requires the interface to provide a squelch input to detect if the radio channel is busy. In RigExpert Plus, the squelch input is assigned to the DCD line of the COM port used for PTT and CW outputs.

- Built-in electronic CW keyer for single or double paddle:
The keyer produces dots or dashes depending on the direction a paddle is pushed to. If using double paddle, squeezing both paddles gives alternating dots and dashes. The speed a CW message comes out with is set by computer software or a built-in potentiometer. A famous WINKEY micro controller (version 10) was chosen as a CW keyer in RigExpert Plus. In RigExpert Plus, a separate COM port is assigned to the WINKEY controller

logos